Fiat 500 Forum banner
1 - 11 of 11 Posts

·
Registered
2013 Pop, manual, Abarth springs, kyb gas a just rear, zonker short shot air filter, Sprint booster
Joined
·
182 Posts
Discussion Starter · #1 ·
Changed PCV box O ring seal and it looks like rubber or some kinda hard rubbery gunk in there. Car runs great in every way. Didn't try much to pull out thinking maybe normal.... Anyone know why or what?
 

Attachments

·
Registered
Joined
·
13,463 Posts
I haven’t got any idea. Might check with the dealer. Are there any other used 500’s, in your area, you can check out?

110373
 

·
Registered
Joined
·
954 Posts
Looks like a sloppy application of rtv silicone sealant during a prior repair, perhaps. Or just a little excess if it’s supposed to be there.
 

·
Registered
2013 Pop, manual, Abarth springs, kyb gas a just rear, zonker short shot air filter, Sprint booster
Joined
·
182 Posts
Discussion Starter · #4 ·
Does not seem to be issue at all and it does not seem to be going anywhere. Was just curious and if anyone else has same. Thanks for replies!
 

·
Registered
2013 Pop, manual, Abarth springs, kyb gas a just rear, zonker short shot air filter, Sprint booster
Joined
·
182 Posts
Discussion Starter · #6 ·
No, its on driver side of engine under pcv box....hole on valve cover to vent pressure
 

·
Registered
Joined
·
2 Posts
It’s the rubber valve cover gasket there in the corner. I just had my valve cover gasket off this week.
 

·
Registered
2013 Pop, manual, Abarth springs, kyb gas a just rear, zonker short shot air filter, Sprint booster
Joined
·
182 Posts
Discussion Starter · #10 ·
(y)
 
1 - 11 of 11 Posts
Top